CompacPRO cases can be used as a desk-top case or with a handle as a mobile unit. CompacPRO cases are used to house 19”-compatible or custom assemblies and plug-in units. The case makes numerous versions possible through its assembly options. Necessary modifications, such as other depths, cut-outs and silk screen printing, are also possible. All assembly and accessory parts of the europacPRO 19” subrack range can be used. The size of the depth grid for internal assembly with these components is 15 mm. Integrated screw channels on the inside of the side panels allow for the assembly of further components at any possible height of the case depth.Furthermore, all accessories can be easily installed from the outside.The entire assembly of the case is very simple: the side panels are already mounted onto the frame; if required, horizontal and guide rails are installed and then the boards are assembled.The top cover is screwed to small die-cast pieces with integrated threads. The front and rear of the case are identical, as more and more often boards with front panels are also assembled at the rear. For optimum cooling ventilation slots are integrated in the base plate. CompacPRO cases are available in the following heights: 2/3/4/6 U, widths up to: 28/42/63/84 HP and depths from 271 to 511 mm. As a standard, the case compacPRO is available in the colours of white aluminium (RAL 9006) and anthracite (RAL 7016). A continuous front panel (plain or glazed) without visible screws provides an aesthetic appearance. Degree of protection IP20. These cases are available in the following heights: 2/3/4 U, widths up to: 28/42/63/84 HP and depths from 271 to 511 mm. Cases prepared for fitting the backplane. Additional components, such as front panels, guide rails, handles, and other, as necessary, should be ordered separately.